Nissan Rogue Service Manual: Dtc/circuit diagnosis
- U0073 communication bus a OFF
- U0100 lost communication (ECM A)
- U0102 lost communication (Transfer)
- U0140 lost communication (BCM)
- U0141 lost communication (BCM A)
- U0155 lost communication (IPC)
- U0300 CAN communication data
- U1000 CAN COMM circuit
- U110f lost communication (ECM)
- U1111 lost communication (chassis control module)
- U1117 lost communication (ABS)
- P062F EEPROM
- P0705 transmission range sensor A
- P0706 transmission range sensor A
- P0711 transmission fluid temperature sensor A
- P0712 transmission fluid temperature sensor A
- P0713 transmission fluid temperature sensor A
- P0715 input speed sensor A
- P0717 input speed sensor A
- P0740 torque converter
- P0743 torque converter
- P0744 torque converter
- P0746 pressure control solenoid A
- P0776 pressure control solenoid B
- P0778 pressure control solenoid B
- P0779 pressure control solenoid B
- P0841 transmission fluid pressure SEN/SW A
- P0847 transmission fluid pressure SEN/SW B
- P0848 transmission fluid pressure SEN/SW B
- P084c transmission fluid pressure SEN/SW H
- P084d transmission fluid pressure SEN/SW H
- P0863 TCM communication
- P0890 TCM
- P0962 pressure control solenoid A
- P0963 pressure control solenoid A
- P0965 pressure control solenoid B
- P0966 pressure control solenoid B
- P0967 pressure control solenoid B
- P2765 input speed sensor B
- P2813 select solenoid
- P2814 select solenoid
- P2815 select solenoid
- Main power supply and ground circuit
- Overdrive control switch
- O/D off indicator lamp
- Shift position indicator circuit
- Shift lock system
CVT position
Inspection
Turn ON the ignition switch with the shift selector at the “P” position.
Press the shift selector button with the brake pedal depressed,
and confirm that the shift select ...
U0073 communication bus a OFF
DTC Description
DTC DETECTION LOGIC
DTC
CONSULT screen terms
(Trouble diagnosis content)
DTC detection condition
U0073
COMM BUS A OFF
(Control Module Communication Bus ...
Other materials:
P0138 HO2S2
DTC Description
DTC DETECTION LOGIC
The heated oxygen sensor 2 has a much longer switching time between rich and
lean than the air fuel ratio (A/
F) sensor 1. The oxygen storage capacity of the three way catalyst (manifold)
causes the longer switching
time.
MALFUNCTION A
To judge the malfu ...
Symptom diagnosis
SQUEAK AND RATTLE TROUBLE DIAGNOSES
Work Flow
CUSTOMER INTERVIEW
Interview the customer if possible, to determine the conditions that exist
when the noise occurs. Use the Diagnostic
Worksheet during the interview to document the facts and conditions when the
noise occurs and any
custome ...
Heater operation
Heating
This mode is used to direct heated air to the foot
outlets. Some air also flows from the defrost
outlets and the side vent outlets.
Press the button to
change to fresh
air intake mode. The indicator
light
will turn off for normal heating.
Press the air flow ...
