Nissan Rogue Service Manual: DTC/circuit diagnosis
- C1704, C1705, C1706, C1707 low tire pressure
- C1708, C1709, C1710, C1711 transmitter (no data)
- C1716, C1717, C1718, C1719 transmitter (pressure data)
- C1729 vehicle speed signal
- C1730, C1731, C1732, C1733 flat tire
- C1734 BCM
- C1735 ignition signal
- C1765, C1766, C1767, C1768 tire pressure sensor
- C1769 configuration setting
- C1770, C1771, C1772, C1773 G sensor
- U1000 CAN COMM CIRCUIT
- U1010 control unit (CAN)
- Low tire pressure warning lamp
- Power supply and ground circuit
ID registration procedure
Description
This procedure must be performed after replacement of a tire pressure sensor
or BCM.
Work Procedure
TPMS ID registration can be performed using one of the following procedures:
&n ...
C1704, C1705, C1706, C1707 low tire pressure
DTC Logic
NOTE:
The Signal Tech II Tool [- (J-50190)] can be used to perform the following
functions. Refer to the Signal Tech II
User Guide for additional information.
Activate and dis ...
Other materials:
Difference between predictive and actual
distances
Backing up on a steep uphill
When backing up the vehicle up a hill, the distance
guide lines and the vehicle width guide
lines are shown closer than the actual distance.
For example, the display shows 3 ft (1.0 m) to the
place A , but the actual 3 ft (1.0 m) distance on
the hill is the p ...
Removal and installation
NATS ANTENNA AMP.
Removal and Installation
REMOVAL
Remove the steering column covers. Refer to IP-17, "Removal and
Installation".
Disconnect the harness connector from the NATS antenna amp.
Release pawls and remove NATS antenna amp. (1) from the
ignition sw ...
Fuel level sensor signal circuit
Component Function Check
1.COMBINATION METER INPUT SIGNAL
Select "METER/M&A" on "CONSULT".
Using "FUEL METER" of "Data Monitor", compare the value of "Data
Monitor" with fuel gauge pointer of
combination meter.
Does ...
