Nissan Rogue manuals

Nissan Rogue Service Manual: Removal and installation

Nissan Rogue Service Manual / Electrical & power control / Power Control System / IPDM E/R / Removal and installation

IPDM E/R (INTELLIGENT POWER DISTRIBUTION MODULE ENGINE ROOM)

Exploded View

Exploded View

  1. IPDM E/R cover
  2. IPDM E/R
  3. IPDM E/R case
  4. IPDM E/R harness cover A
  5. IPDM E/R harness cover B

Front

Removal and Installation

CAUTION:  IPDM E/R integrated relays are not serviceable parts, do not remove from the IPDM E/R.

REMOVAL

  1.  Disconnect the negative battery terminal. Refer to PG-75, "Removal and Installation (Battery)".
  2.  Remove air duct (inlet). Refer to EM-24, "Exploded View".
  3. Release pawls on IPDM E/R cover (1) and remove.

    : Pawls

Removal

  1. Release pawls and remove IPDM E/R (1) from the IPDM E/R case (2).

    : Pawls

Removal

  1. Disconnect the harness connectors from IPDM E/R (1).

    CAUTION: Replace the IPDM E/R if it has been dropped or sustained an impact.

Removal

  1. Release the negative battery cable and harness clips from the IPDM E/R case.
  2. Release the pawls on the IPDM/ E/R harness covers A, B and remove from the IPDM E/R case.
  3. Remove the bolts from the IPDM E/R case.
  4. Remove the bolt (A) from the fusible link box (battery).

Removal

  1. Release the pawls on the fusible link box (battery) case (2) and remove from the IPDM E/R case (1).

    : Pawls

Removal

INSTALLATION

Installation is in the reverse order of removal.

DTC/circuit diagnosis
U1000 CAN COMM CIRCUIT Description Refer to LAN-8, "System Description". DTC Logic DTC DETECTION LOGIC CONSULT Display DTC Detection Condition Possible Cause ...

Power distribution system
...

Other materials:

Power generation voltage variable control system operation inspection
Diagnosis Procedure Regarding Wiring Diagram information. Refer to CHG-7, "Wiring Diagram". CAUTION: When performing this inspection, always use a charged battery that has completed the battery inspection. (When the charging rate of the battery is low, the response speed of the vol ...

Inside mirror
Wiring Diagram - With Homelink Universal Transceiver Wiring Diagram - Without Homelink Universal Transceiver ...

Heated seats (if so equipped)
The front seats are warmed by built-in heaters.  Start the engine.  Push the LO or HI position of the switch, as desired. The indicator light in the switch will illuminate. The heater is controlled by a thermostat, automatically turning the heater on and off. The in ...

В© 2014-2024 Copyright www.nirogue.com