Nissan Rogue manuals

Nissan Rogue Owners Manual: Controls

Fan control dial

The fan control dial turns the fan on and off, and controls fan speed.

Air flow control buttons

The air flow control buttons allow you to select the air flow outlets.

MAX A/C — Air flows mainly from center and side vents with maximum cooling and turns on.
— Air flows mainly from center and side vents.
— Air flows mainly from center and side vents and foot outlets.
— Air flows mainly from foot outlets and partly from defroster.
— Air flows mainly from defroster outlets and foot outlets.
— Air flows mainly from defroster outlets.

Temperature control dial The temperature control dial allows you to adjust the temperature of the outlet air. To lower the temperature, turn the dial to the left. To increase the temperature, turn the dial to the right.

Air recirculation button

On position (Indicator light on):

Interior air is recirculated inside the vehicle.

Press the button to the ON position when:

Off position (Indicator light off):

Outside air is drawn into the passenger compartment and distributed through the selected outlet.

Use the off position for normal heater or air conditioner operation.

Air conditioner button

Start the engine, turn the fan control dial to the desired position and press the button to turn on the air conditioner. To turn off the air conditioner, press the button again.

The air conditioner cooling function operates only when the engine is running.

Rear window and outside mirror (if so equipped) defroster button

For additional information, refer to “Rear window and outside mirror (if so equipped) defroster switch” in the “Instruments and controls” section of this manual.

Heater and Air Conditioner (manual) (if so equipped)
Heater and Air Conditioner Fan speed control / system OFF dial / air conditioning (A/C) button   Air flow control buttons  Temperature control dial / MAX A/C button   ...

Heater operation
Heating This mode is used to direct heated air to the foot outlets. Some air also flows from the defrost outlets and the side vent outlets.  Press the button to change to fresh air i ...

Other materials:

Symptom diagnosis
SQUEAK AND RATTLE TROUBLE DIAGNOSES Work Flow CUSTOMER INTERVIEW Interview the customer if possible, to determine the conditions that exist when the noise occurs. Use the Diagnostic Worksheet during the interview to document the facts and conditions when the noise occurs and any custome ...

Illumination
Wiring Diagram ...

B142X collision detection
Description DTC B1209 - B1211 COLLISION DETECTION The air bag diagnosis sensor unit will set this DTC if it has detected a collision which has resulted in a deployment of one or more air bags or pre-tensioners. If this DTC is detected after a SRS repair, the air bag diagnosis sensor unit has ...

© 2014-2025 Copyright www.nirogue.com