Nissan Rogue Service Manual: Seat belt warning system

Nissan Rogue Service Manual / Restraints / SRS Airbag Control System / Symptom diagnosis / Seat belt warning system

Seat Belt Warning System Does Not Function

1.SEAT BELT WARNING LIGHT

Turn ignition switch ON.

Does the seat belt warning lamp come ON? YES >> GO TO 2.

NO >>

Check 10A fuse [No. 13, located in the fuse block (J/B)].
Check seat belt buckle switch (driver seat).
Check harness between combination meter and seat belt buckle switch (driver seat).
Check combination meter. Refer to MWI-29, "Fail-safe".

2.SEAT BELT BUCKLE (DRIVER SEAT)

Fasten the seat belt buckle (driver seat).

Does the seat belt warning lamp go OFF? YES >> GO TO 3.

NO >>

Check seat belt buckle switch (driver seat).
Check harness between combination meter and seat belt buckle switch (driver seat).

3.OCCUPANT CLASSIFICATION SYSTEM

Have a helper sit in the passenger seat.

Does the seat belt warning lamp go ON? YES >> GO TO 4.

NO >>

Check occupant classification system. Refer to SRC-13, "OCCUPANT CLASSIFICATION SYSTEM : System Description".
Check harness between occupant classification control unit and air bag diagnosis sensor unit.

4.SEAT BELT BUCKLE (PASSENGER SEAT) Fasten the seat belt buckle (passenger seat).

Does the seat belt warning lamp go OFF? YES >> System OK.

NO >>

Check seat belt buckle switch (passenger seat).
Check harness between seat belt buckle switch (passenger seat) and air bag diagnosis sensor unit.
Replace air bag diagnosis sensor unit. Refer to SR-26, "Removal and Installation".

SRS air bag warning lamp does not turn off

AIR BAG Warning Lamp Does Not Turn Off 1.CHECK CONDITION OF AIR BAG MODULE Inspect for any deployed air bag modules or seat belt pre-tensioners. Are any air bag modules or seat belt pre-tensioner ...

Ventilation, heater & air conditioner

...

Other materials:

System
System Description When the vehicle has reached a speed of 40 km/h (25 MPH) or greater, the BCM receives a signal transmitted from the tire pressure sensors installed in each wheel. If the BCM detects low inflation pressure or a system malfunction, it sends a signal to the combination meter v ...

Exterior front
Front view camera (if so equipped) Engine hood Windshield wiper and washer switch, wiper blades Windshield-washer fluid Windshield Power windows Door locks, NISSAN Intelligent Key® (if so equipped), NISSAN Jackknife key (if so equipped), key ...

Accelerator pedal released position learning
Description Accelerator Pedal Released Position Learning is a function of ECM to learn the fully released position of the accelerator pedal by monitoring the accelerator pedal position sensor output signal. It must be performed each time harness connector of accelerator pedal position sensor ...