Diagnosis Description
This system is an on board diagnostic system that records exhaust emission-related diagnostic information and detects a sensors/actuator-related malfunction. A malfunction is indicated by the malfunction indicator lamp (MIL) and stored in control module memory as a DTC. The diagnostic information can be obtained with the diagnostic tool (GST: Generic Scan Tool).
GST (Generic Scan Tool)
When GST is connected with a data link connector equipped on the vehicle side, it will communicate with the control module equipped in the vehicle and then enable various kinds of diagnostic tests. Refer to EC-56, "Diagnosis Description".
NOTE: Service $0A is not applied for regions where it is not mandated.
Operation
Diagnosis system (ECM)Brake pedal position switch
Component Function Check
1.CHECK BRAKE PEDAL POSITION SWITCH FUNCTION
With CONSULT
Turn ignition switch ON.
Select “BRAKE SW1” in “DATA MONITOR” mode with CONSULT.
Check “BRAKE SW1” indication as per the following conditions.
Without CONSULT
  ...
The key warning does not sound (without intelligent key)
Description
The key warning chime does not sound, when all of the following conditions
are fulfilled:
Key inserted into the key cylinder (key switch signal ON).
Ignition switch is in OFF position (ignition switch signal OFF).
Driver side door is open (front door switch L ...
Steering gear and linkage
Exploded View
REMOVAL AND INSTALLATION
Cotter pin
Steering gear
Heat shiel
Removal and Installation
REMOVAL
Set the front wheels and tires to the straight-ahead position.
Remove the floor cover. Refer to ST-12, "Exploded View".
Remov ...