Nissan Rogue Service Manual: Dtc/circuit diagnosis

Inspection and adjustment

ADDITIONAL SERVICE WHEN REPLACING CONTROL UNIT ADDITIONAL SERVICE WHEN REPLACING CONTROL UNIT : Special Repair Requirement INITIALIZATION PROCEDURE Moonroof If the moonroof does not open or clos ...

Power supply and ground circuit

BCM (BODY CONTROL SYSTEM) (WITH INTELLIGENT KEY SYSTEM) BCM (BODY CONTROL SYSTEM) (WITH INTELLIGENT KEY SYSTEM) : Diagnosis Procedure Regarding Wiring Diagram information, refer to BCS-50, "Wi ...

Other materials:

Wheel alignment
Inspection DESCRIPTION  Measure wheel alignment under unladen conditions. NOTE: “Unladen conditions” means that fuel, engine coolant, and lubricants are full. Spare tire, jack, hand tools and mats are in designated positions. PRELIMINARY CHECK Check the following: &nbs ...

CAN system (type 5)
MAIN LINE BETWEEN IPDM-E AND DLC CIRCUIT Diagnosis Procedure 1.CHECK CONNECTOR  Turn the ignition switch OFF.  Disconnect the battery cable from the negative terminal.  Check the following terminals and connectors for damage, bend and loose connection (connector side an ...

Steering wheel
Inspection STEERING WHEEL AXIAL END PLAY  Check installation conditions of steering gear, front suspension assembly, axle and steering column.  Check if movement exists when steering wheel is moved up and down, to the left and right and to the axial direction. Steering wh ...