Nissan Rogue Owners Manual: Continuously Variable Transmission (CVT) fluid

Nissan Rogue Owners Manual / Maintenance and do-it-yourself / Engine oil / Continuously Variable Transmission (CVT) fluid

CAUTION

NISSAN recommends using Genuine NISSAN CVT Fluid NS-3 ONLY in NISSAN CVTs. Do not mix with other fluids.
Do not use Automatic transmission fluid (ATF) or Manual transmission fluid in a NISSAN CVT, as it may damage the CVT. Damage caused by the use of fluids other than recommended is not covered under NISSAN’s New Vehicle Limited Warranty.
Using fluids that are not equivalent to Genuine NISSAN CVT Fluid NS-3 may damage the CVT. Damage caused by the use of fluids other than as recommended is not covered under NISSAN’s New Vehicle Limited Warranty.

When checking or replacement of CVT fluid is required, we recommend your NISSAN dealer for servicing.

Changing engine oil filter

> Changing engine oil filter Park the vehicle on a level surface and apply the parking brake. Turn the engine off. Place a large drain pan under the oil filter B . Remove pins ...

Brake fluid

Brake fluid Check the brake fluid level in the reservoir. If the brake warning light comes on, add Genuine NISSAN Super Heavy Duty Brake Fluid or equivalent DOT 3 fluid up to the MAX line. If fl ...

Other materials:

Precaution
Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT PRE-TENSIONER" The Supplemental Restraint System such as “AIR BAG” and “SEAT BELT PRE-TENSIONER”, used along with a front seat belt, helps to reduce the risk or severity of injury to the ...

Operating the power liftgate (if so equipped)
WARNING Make sure that all passengers have their hands, etc., inside the vehicle before closing the liftgate. Do not leave children unattended inside the vehicle. They could unknowingly activate switches or controls. Unattended children could become inv ...

Inspection and adjustment
ADDITIONAL SERVICE WHEN REPLACING CONTROL UNIT ADDITIONAL SERVICE WHEN REPLACING CONTROL UNIT : Description When replacing the occupant classification system control unit, perform zero point reset procedure. Refer to SRC-42, "ZERO POINT RESET : Special Repair Requirement". When ...