Nissan Rogue Service Manual: Removal and installation

Rear disc brake

Brake Burnishing CAUTION:  Burnish contact surfaces between brake pads and disc brake rotor according to the following procedure after refinishing the disc brake rotor, replacing brake ...

Brake pedal

Exploded View Rivet Clevis pin Brake pedal  Brake pedal pad Clip Snap pin  Stop lamp switch  Brake pedal position switch Removal and Installation REMOVAL ...

Other materials:

Diagnosis system (ECM)
DIAGNOSIS DESCRIPTION DIAGNOSIS DESCRIPTION : 1st Trip Detection Logic and Two Trip Detection Logic When a malfunction is detected for the first time, 1st trip DTC and 1st trip Freeze Frame data are stored in the ECM memory. The MIL will not illuminate at this stage. <1st trip> If the ...

Spiral cable
Exploded View Combination switch Steering angle sensor Spiral cabl Removal and Installation WARNING:  Before servicing the SRS, turn ignition switch OFF, disconnect both battery terminals then wait at least three minutes.  Do not use the air tools or electric t ...

Key switch signal circuit (without intelligent key)
Description Transmits a key switch signal to the BCM. Component Function Check 1. CHECK BCM INPUT SIGNAL Select "Data Monitor" for "BCM" and check the "KEY ON SW" monitor value. Is the inspection result normal? YES >> Inspection End. NO >> Refer ...