Nissan Rogue Owners Manual: Flat towing for All–Wheel drive vehicle (if so equipped)

Nissan Rogue Owners Manual / Technical and consumer information / Towing a trailer / Flat towing for All–Wheel drive vehicle (if so equipped)

Towing your vehicle with all four wheels on the ground is sometimes called flat towing. This method is sometimes used when towing a vehicle behind a recreational vehicle, such as a motor home.

CAUTION

Failure to follow these guidelines can result in severe transmission damage.
Whenever flat towing your vehicle, always tow forward, never backward.
DO NOT tow your All-wheel drive (AWD) vehicle with any wheels on the ground.
Doing so may cause serious and expensive damage to the powertrain.
For emergency towing procedures refer to “Towing recommended by NISSAN” in the “In case of emergency” section of this manual.

Towing safety

Trailer hitch Your vehicle may be equipped with an optional trailer tow package. The trailer tow package includes a receiver-type frame mounted hitch. This hitch is rated for the maximum towing ca ...

Flat towing for front wheel drive vehicle (if so equipped)

Towing your vehicle with all four wheels on the ground is sometimes called flat towing. This method is sometimes used when towing a vehicle behind a recreational vehicle, such as a motor home. ...

Other materials:

Unit disassembly and assembly
REAR DRIVE SHAFT Exploded View DISASSEMBLY Circular clip Dust shield Slide joint housing Snap ring Spider assembly Boot band Boot Shaft Circular clip Joint sub-assembly Sensor rotor : Wheel side Disassembly and Assembly DISASSEMBLY Final Dri ...

Removal and installation
ECM Removal and Installation EXPLODED VIEW 1 ECM bracket 2 ECM : Vehicle front CAUTION: Perform ADDITIONAL SERVICE WHEN REPLACING ECM. Refer to EC-136, "Work Procedure". REMOVAL Disconnect the battery negative terminal. Remove the resonator. Refer to EM-24 ...

B142A ignition voltage
Description DTC B142A IGNITION VOLTAGE Ignition voltage is supplied to the air bag diagnosis sensor unit when the ignition is in the ON position. The air bag diagnosis sensor unit will monitor for low or high ignition voltage. PART LOCATION Refer to SRC-6, "Component Parts Location" ...