Additional service when replacing ECM
Description
When replacing ECM, the following procedure must be performed. (For details,
refer to EC-136, "Work Procedure".)
PROGRAMMING OPERATION
NOTE:
After replacing with a blank ECM, programming is required to write ECM
information. Be sure to follow the procedure
to perform t ...
C1142 press sensor
DTC Logic
DTC DETECTION LOGIC
DTC
Display Item
Malfunction detected condition
Possible causes
C1142
PRESS SEN CIRCUIT
When a malfunction is detected in master cylinder
pressure sensor
Stop lamp switch system
ABS actuator and electric unit
...
Steering wheel
Inspection
STEERING WHEEL AXIAL END PLAY
Check installation conditions of steering gear, front suspension
assembly, axle and steering column.
Check if movement exists when steering wheel is moved up and down,
to the left and right and to the axial
direction.
Steering wh ...